16
Configure your MFPMFP
The following settings are the minimum required to perform basic
functions such as print, copy, fax, or e-mail.
Setting thehe
IP address
You must have an IP address for network devices to find the MFP on P address for network devices to find the MFP on
the network. If you have DHCP, the proper address values are
automatically assigned. matically assigned.
To check your IP address, or to assign one manually if you do not
have DHCP:
1 From the Home screen, touch the Key icon, and then touch
System Configuration.
2 Under the Printer/Print Server heading, touch Setup and
Configuration.
3 Under the Print Server heading, touch TCP/IP.
4 Address, Netmask, and Gateway are required fields, and Netmask, and Gateway are required fields, and
should have nonzero values. If necessary, use the virtual
keyboard and enter the appropriate information for your
network. Set any additional information you want.
5 Touch Submit when you are finished entering information. g information.
6 Wait for the configuration page to refresh, then verify the
parameters are as intended.
After configuring the IP address, you can use your Web browser to
remotely view and manage the MFP. Type the IP address in the URL MFP. Type the IP address in the URL
field of the browser (for example, http://192.168.236.24) and press mple, http://192.168.236.24) and press
Enter.
Configuringonfiguring
Scan to E-mailto E-mail
1 Type the MFP IP address in your Web browser URL field and FP IP address in your Web browser URL field and
then press Enter.
To Next Page
Loading...
