52
2. Bluetooth
®
SETTINGS
LS460_600h_Navi_U
3 Select the desired connection.
When another Bluetooth
®
device is con-
nected
To disconnect the Bluetooth
®
device,
select “Yes”.
4 Check that a confirmation screen is dis-
played when the connection is com-
plete.
If an error message is displayed, follow the
guidance on the screen to try again.
■ AUTO CONNECTION MODE
When the engine <power> switch is in
ACCESSORY or IGNITION ON <ON>
mode, the system searches for a nearby
registered device.
The system will connect with the registered
device that was last connected, if it is
nearby.
■ CONNECTING MANUALLY
1 Press the “MENU” button on the
Remote Touch and select “Setup”.
2 Select “Bluetooth*”.
3 Follow the steps in “CONNECTING A
Bluetooth
®
DEVICE” from “STEP 2”.
(P. 51)
*: Bluetooth is a registered trademark of
Bluetooth SIG, Inc.
●It may take time if the device connection
is carried out during Bluetooth
®
audio
playback.
●Depending on the type of Bluetooth
®
device being connected, it may be neces-
sary to perform additional steps on the
device.
●When disconnecting a Bluetooth
®
device, it is recommended to disconnect
using the system.
To turn auto connection mode on, set
“Bluetooth* Power” to on. (P. 56)
Leave the Bluetooth
®
device in a loca-
tion where the connection can be estab-
lished.
When the auto connection has failed or
“Bluetooth* Power” is turned off, it is
necessary to connect Bluetooth
®
man-
ually.
To Next Page
Loading...
