Lexus LS460 - Switching the Door Unlock Function

130
3-2. Opening, closing and locking the doors and trunk
LS460_EE (OM50D49E)
 Switching the door unlock function
It is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the engine switch off.
Cancel the intrusion sensor and tilt sensor of the alarm system to prevent
unintended triggering of the alarm during the setting change (if equipped).
(P. 91)
Press and hold or for approximately 5 seconds while pressing
and holding .
The setting changes each time an operation is performed, as shown below.
(When changing the setting continuously, release the buttons, wait for at least
5 seconds, and repeat step .)
For vehicles with an alarm: To prevent unintended triggering of the alarm,
unlock the doors using the wireless remote control and open and close a door
once after the settings have been changed. (If a door is not opened within 30
seconds after is pressed, the doors will be locked again and the alarm
will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P. 89)
1
2
3
3
Multi-information
display
Unlocking function Beep
Hold a door handle to
unlock all doors
Exterior: Beeps
twice
Interior: Rings once
Hold the driver’s door han-
dle to unlock only the
driver’s door
Exterior: Beeps 3
times
Interior: Rings once
Hold a passenger’s door
handle to unlock all the
doors
Hold the door handle to
unlock the front and rear
doors on your side
Exterior: Beeps 4
times
Interior: Rings once
Hold the door handle to
unlock the door
Exterior: Beeps
once
Interior: Rings once