170
3-3. Adjusting the seats
LS460_EE (OM50D49E)
Operating the driving position memory after turning the engine switch off
Driver's seat:
Recorded driving positions (except the steering wheel position) can be
recalled up to 180 seconds after the driver’s door is opened and up to 60 sec-
onds after it is closed again.
Front passenger's seat:
Recorded seat positions can be recalled up to 180 seconds after the front pas-
senger's door is opened.
In order to correctly use the driving position memory function
If a seat position is already in the furthest possible position and the seat is
operated in the same direction, the recorded position may be slightly differ-
ent when it is recalled.
Each electronic key (including a card key) can be registered to
recall your preferred driving position.
Registering procedure
Record your driving position to switch “1”, “2” or “3” before
performing the following:
Using the wireless remote control
Turn the engine switch off and close the driver's door.
While pressing the desired
switch (“1”, “2” or “3”),
press on the wireless
remote control until the
buzzer sounds.
To prevent unintended triggering of the alarm, open and close a
door once after a driving position has been recorded. (If a door is
not opened within 30 seconds after
is pressed, the doors will
be locked again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm.
Memory recall function (driver's side only)
To Next Page
Loading...
