Lexus LS460 - Page 174

169
3-3. Adjusting the seats
3
Operation of each component
LS460_EE (OM50D49E)
 Recall procedure
Check that the shift lever is in P.
Turn the engine switch to IGNITION ON mode.
Press one of the switches
for the driving position you
want to recall until the
buzzer sounds.
 When you want to stop the position recall operation part-way through
Perform any of the following operations:
 Press the “SET” switch.
 Press switch “1”, “2” or “3”.
 Operate any of the seat adjustment switches (only cancels seat position
recall).
 Operate the tilt and telescopic steering control switch (only cancels steering
wheel position recall).
 Operate the seat belt shoulder anchor height adjusting switch (only cancels
height of seat belt shoulder anchor recall).
 Front passenger’s seat position recall limitations (vehicles with front passen-
ger ottoman)
The memorized position will only be recalled if the front passenger ottoman
is in a position higher than the memorized position. It will not move in an
upward direction.
 Automatic front passenger ottoman adjustment (if equipped)
While the memorized position is being recalled, if it appears that the front
edge of the cushion will make contact with the area surrounding the instru-
ment panel, the front passenger ottoman will be automatically stowed.
1
2
3