172
3-3. Adjusting the seats
LS460_EE (OM50D49E)
Using the door lock switch
Carry only one of the keys (including the card key) to which you
want to link the driving position. If 2 or more keys are in the
vehicle, the driving position cannot be linked properly.
Turn the engine switch off and close the driver's door.
While pressing the recalled
switch, press and hold the
door lock switch (either
lock or unlock) until the
buzzer sounds.
Recall procedure
Carry the electronic key that has been registered to the driving
position, and then unlock and open the driver's door using the
smart entry & start system or wireless remote control.
The driving position will move to the recorded position (not including
the steering wheel). However, the seat will move to a position slightly
behind the recorded position in order to make entering the vehicle eas-
ier.
If the driving position is in a position that has already been recorded,
the seat and outside rear view mirrors will not move.
Turn the engine switch to ACCESSORY mode or fasten your
seatbelt.
The seat and steering wheel will move to the recorded position.
Cancelation procedure
Using the wireless remote control
Turn the engine switch off and close the driver’s door.
While pressing the “SET” switch, press on the wireless
remote control until the buzzer sounds.
To Next Page
Loading...
