859
7-2. Steps to take in an emergency
7
When trouble arises
LS460_EE (OM50D49E)
With the compressor switch off, disconnect the hose from the
valve on the tire and then pull out the power plug from the power
outlet socket.
Some sealant may leak when the hose is removed.
Install the valve cap onto the valve of the emergency repaired
tire.
Attach the air release cap to
the end of the hose.
If the air release cap is not
attached, the sealant may leak and
the vehicle may get dirty.
Temporarily store the bottle in the trunk while it is connected to
the compressor.
To spread the liquid sealant evenly within the tire, immediately
drive safely for about 5 km (3 miles) below 80 km/h (50 mph).
After driving, stop your vehi-
cle in a safe place on a hard,
flat surface and reconnect the
compressor.
To Next Page
Loading...
