175
3-6. Favorite settings
3
Before driving
ment in My Settings.
Registering procedure
When the shift lever is shifted to P after
driving the vehicle, the current driving
position will be recorded.
Recall procedure
Turn the power switch to ACC or ON.
After face authentication is performed suc-
cessfully, the seat, steering wheel, and
head-up display (if equipped) (only when
the power switch is turned to ON) move to
the registered driving position.
If the driving position is in a position that
has already been recorded, the driving
position will not move.
Cancelation procedure
Delete face information from the face
authentication system.
For information on deleting face informa-
tion, refer to “MULTIMEDIA OWNER’S
MANUAL”.
■ When My Settings is turned off:
Each electronic key can be registered
to automatically recall your preferred
driving position.
Driving position registration proce-
dure
Record your driving position to button “1”,
“2” or “3” before performing the following:
Carry only the key you want to register,
and then close the driver’s door.
If 2 or more keys are in the vehicle, the
driving position cannot be recorded prop-
erly.
1 Check that the shift position is in P.
2 Turn the power switch to ON.
3 Recall the driving position that you
want to record.
4 While pressing the recalled button,
press and hold the door lock switch
(either lock or unlock) until the
buzzer sounds.
If the button could not be registered, the
buzzer sounds continuously for approxi-
mately 3 seconds.
Driving position recall procedure
1 Carry the electronic key that has
been registered to the driving posi-
tion, and then unlock and open the
driver’s door using the smart
access system with push-button
start or wireless remote control.
The driving position other than the steering
wheel and head-up display (if equipped)
will move to the recorded position. How-
ever, the seat will move to a position
slightly behind the recorded position in
order to make entering the vehicle easier.
If the driving position is in a position that
has already been recorded, the driving
position will not move.
2 Turn the power switch to ACC or
ON, or fasten a seat belt.
The seat, steering wheel and head-up dis-
play (if equipped) (only when the power
switch is in ON) will move to the recorded
position.
Memory recall function cancelation
procedure
Carry only the key you want to cancel and
then close the driver’s door.
To Next Page
Loading...
