546
5-6. Using the other interior features
Vehicles with Digital Rear-view
Mirror
Programming a device other than
an entry gate (for U.S.A. owners)
Press and hold the remote control trans-
mitter button until the HomeLink
®
indica-
tor light changes from slowly flashing
orange to rapidly flashing green (rolling
code) or continuously lit green (fixed
code), then release the button.
Programming an entry gate (for
U.S.A. owners)/Programming a
device in the Canadian market
Press and release the remote control
transmitter button at 2 second intervals,
repeatedly, until the HomeLink
®
indicator
light changes from slowly flashing (orange)
to rapidly flashing (green) (rolling code) or
continuously lit (green) (fixed code).
4 Test the HomeLink
®
operation by
pressing the newly programmed
button and observing the indicator
light:
HomeLink
®
indicator light illumi-
nates: Programming of a fixed code
device has completed. The garage
door or other device should operate
when a HomeLink
®
button is
pressed and released.
HomeLink
®
indicator light flashes
rapidly: The garage door opener
motor or other device is equipped
with a rolling code. To complete
programming, firmly press and hold
the HomeLink
®
button for 2 sec-
onds then release it.
If the garage door or other device
does not operate, proceed to “Pro-
gramming a rolling code system”.
5 Repeat the steps above to program
another device for any of the
remaining HomeLink
®
buttons.
■ Programming a rolling code sys-
tem
Two or more people may be necessary
to complete rolling code program-
ming.
1 Locate the “Learn” or “Smart” but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner’s
manual supplied with the garage door
opener motor for details.
2 Press and release the “Learn” or
“Smart” button.
Perform step 3 within 30 seconds after
To Next Page
Loading...
