SCHEDULE SETTING
38
Low Noise Mode Time
It is the function to set the start and end time of the outdoor unit’s low noise mode operation.
• After setting the start time and the end time, press [OK] button to move to the upper level list.
• If the start time and the current time are the same, it enters the outdoor unit low noise
operation mode, and in the monitoring screen, ‘in outdoor unit low noise operation mode’
message is displayed.
• If the end time and the current time are the same, the outdoor unit low noise operation mode is
cleared.
NOTE
• Low noise mode time setting function can be set only when the installer setting’s outdoor unit
function Master/Slave setting is set to “Master”.
• Low noise mode time setting function is only available in some products.
CAUTION
• When you enter the low noise operation, the heating (cooling) capacity may be degraded.
To Next Page
Loading...
Need help?
General