SAFETY INSTRUCTIONS
8
• Never install the unit on a moving base or a place from where it
can fall down.
− The falling unit can cause damage or injury or even death of a
person.
• When the product is soaked (flooded or submerged) in water,
contact an Authorized Service Center for repair before using it
again.
− There is risk of fire or electric shock.
• Be sure to check the refrigerant to be used. Please read the label
on the product.
− Incorrect refrigerant can prevent the normal operation of the
unit.
• Don't use a power cord, a plug or a loose socket which is
damaged.
− Otherwise it may cause a fire or electrical shock.
• Do not touch , operate, or repair the product with wet hands.
− There is risk of electric shock or fire.
• Do not place a heater or other heating appliances near the power
cable.
− There is risk of fire and electric shock.
• Do not allow water to run into electric parts. Install the unit away
from water sources.
− There is risk of fire, failure of the product, or electric shock.
• Do not store or use or even allow flammable gas or combustibles
near the outdoor unit. (especially in protect zone.)
− There is risk of fire.
• Wiring connections must be secured tightly and the cable should
be routed properly so that there is no force pulling the cable from
the connection terminals.
− Improper or loose connections can cause heat generation or
fire.
To Next Page
Loading...
Need help?
General