To Next Page

To Previous Page

206-4272

The primary purpose of the EZ-Manager Wizard is to guide you through the process (automated or

manual) of configuring the essential Installer Menu items for Pro:Centric operation. The wizard is

initiated once the video output resolution is set (see previous page) and subsequently each time the

STB/display panel is turned ON, until one of its configuration methods has been completed or the

wizard is exited. Use the Installer Remote to make selections and complete each wizard step.

While the EZ-Manager Wizard is intended primarily for Pro:Centric-related conguration, the wizard

also offers Zoning as well as USB conguration options.

• STB-3000s support the TV Zoning and Wi-Fi Zoning features, both of which enable location-

specic settings (see Reference section, “Using the STB’s Zoning Features,” for further information).

The EZ-Manager Wizard enables you to set the TV Zone # and/or the Wi-Fi Zone # in the STB as

part of the conguration process.

• The EZ-Manager Wizard also enables you to redirect to the STB’s standard STB Manager / USB

Download Menu as part of the conguration process, if desired, to perform USB conguration and/

or update functions.

Caution: Do NOT unplug the STB power cord or remove the antenna cable or, if

applicable, the LAN cable during the conguration process, as doing so will interrupt

the current step and may corrupt the conguration data.

Before You Begin

• If you plan to create a Master STB Setup using the procedure described on pages 40 to 42, be

sure to exit the EZ-Manager Wizard in order to avoid setting modes that may restrict the custom

setup procedure. See also “Initiate Conguration or Exit the EZ-Manager Wizard” on the following

page.

• If it has been completed or exited and therefore does not display, the EZ-Manager Wizard can be

reactivated; however, this requires that you restore the STB to a factory default condition. See

Reference section, “Restoring Factory Defaults on the STB(s),” for further information.

• Each wizard step is allotted a time frame after which the wizard proceeds without user interaction. If

the Pro:Centric server is congured on the system and if no location-specic settings are required

in the STB, for example, TV Zone, Wi-Fi Zone, Label, and/or Room Number settings, you can

simply turn ON the STB/display, and once initiated, the wizard will proceed through each of the

conguration steps with no further user interaction.

• If any of the conguration steps fails, you will see a “Diagnostics” screen with an indication of the

failure. You will then have the opportunity to reinitiate the conguration process from the previous

screen or exit the EZ-Manager Wizard.

• If you would like to enable the SoftAP Media Share feature on an STB that will eventually be

congured for FTG Mode, you will need to use the IP Environment Menu to specify the SoftAP

settings before the STB is congured for FTG Mode. Refer to “IP Environment Setup” on pages

55 to 62 for information on the IP Environment Menu. See also “Custom Master STB Setup” on

pages 40 to 42.

EZ-Manager Wizard

LG STB-3000 Setup Guide

Other manuals for LG STB-3000