Liebert NXC - 6.3 Connecting USB Communication Cables

52 User Manual 10H52188UM51 - Rev. 1 - 09/2011
Communication Liebert NXC
Note
1. It is recommended to use 0.82mm
2
~ 0.33mm
2
(signal cable of 18AWG ~ 33AWG) copper core cable.
2. If the switch you have configured is of electronic control tripping function, when the REPO signal takes action, you need to close
the switch before restart the UPS.
6.3 Connecting USB Communication Cables
The USB port is located on the rear panel of the UPS, as shown in Figure 1-3.
The USB port can connect the monitoring software.
The methods to connect the communication cable are as follows:
Insert one end of the USB communication cable to the USB port (see Figure 1-3) on the rear panel of the UPS, and connect the
other end to the USB port of the computer.
After the connection, you need to install the USB drive program in the installation disk.