Radio control identifi cation
he control unit is fi tted with a built-in radio receiver with a 1000 code memory and 2 channels with a 433.92 MHz frequency with LIFE Rolling Code and
2.2.1 STEP command identifi cation
will flash slowly and the
fl ashing light (if present) will emit single fl ashes.
on the radio control(s) that one wants to
dentify and hold down until the green LED
o exit identifi cation, wait approximately 15 seconds until
To exit identifi cation, wait approximately 15 seconds untilT
he two red LEDs fl ash if the travel has not yet been identifi ed,
r the two green LEDs when the travel has already been
t is possible to exit without waiting the automatic exit time
2.2.2 PEDESTRIAN command identifi cation
will flash slowly and the
fl ashing light (if present) will emit double fl ashes.
PLENDOR fl ashing light (if present) will emit double fl ashes.PLENDOR
of the radio control(s) that one wants to
identify and hold down until the green LED
fl ashing light light briefl y.
o exit identifi cation, wait approximately 15 seconds until
To exit identifi cation, wait approximately 15 seconds untilT
he two red LEDs fl ash if the travel has not yet been identifi ed,
he two green LEDs when the travel has already been identifi ed.
t is possible to exit without waiting the automatic exit
2.2.3 Radio control resetting
twice: the two right LEDs and the two left LEDs
ill fl ash alternately while the fl ashing light emits a triple fl ash.
on the radio control(s) that one wishes
o exit identifi cation, wait approximately 15 seconds until
wo red LEDs fl ash if the travel has not yet been identifi ed, or
t
wo red LEDs fl ash if the travel has not yet been identifi ed, or
t
he two green LEDs when the travel has already been identifi ed.
t is possible to exit without waiting the automatic exit time
To Next Page
Loading...
