Liftup North America, Inc. | 5626 56th Commerce Park Blvd | Tampa, FL 33610 | T: +1 844 543 8878 | M: info@liftup.us | www.liftup.us
2.1 Regulatory approvals
FCC/IC
The radio module contained in the FlexStep V2 and associated remote comply with the FCC
Part 15.249 and the Industry Canada requirements RSS-GEN, RSS-210
The radio module contained in the FlexStep V2 and associated remotes complies with Part 15
of the FCC rules and with Industry Canada license exempt standard(s). Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
The radio module contained in the FlexStep V2 and associated remotes are SAR test excluded
according to FCC KDB 447498, RSS102 and EN 62479 at separation distances larger than 5 mm
and less than 50 mm.
With respect to radio frequency radiation exposure Information, it is declared; that this equip-
ment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This gives an extra margin, since the remote control normally, only is used in “controlled
environment” for approx. 30 seconds when lifting, and typically only a few times a day.
EU Declaration of Conformity: CE
(Machinery Directive and RED (Radio module and remote))
ASME 18.1 2014 (US/FDA)
The FlexStep V2 complies with key requirements of the ASME 18.1 Safety Standard for Platform
lifts and Stairway Chairlifts, section 5 “Private Residence Platform Lifts”. Please note that not all
possible configurations of the FlexStep V2 are in compliance – consult your reseller for further
information.
ACMA (AUS/NZ)
The FlexStep V2 complies with the Australian/New Zealand Radio communication Act 2400-
2483 MHz, and is labelled accordingly:
To Next Page
Loading...
