DP-OPT-TX150, DP-OPT-RX150 – User's Manual 18
Control menu
Connected text is
displayed in the extender’s title that is connected to the computer directly.
Parameter State and Description
Fiber link
Connected: Transmitter and Receiver are linked
Disconnected:
DP link speed and channels According to the incoming signal (only in DP mode)
Video mode
DisplayPort
HDMI: passive adaptor is connected to the receiver
Video source state
ON: source is present in DP mode
Not connected: source is not connected
n/a: no information about the signal (HDMI mode)
Monitor state
ON: DP or HDMI display
OFF: display device is not connected
checked:
unchecked:
Video and Link Panel
cable, they can read information about each other and display.
INFO: Source can be forced to send unencrypted signal (if the content allows) by unchecking the HDCP
enable setting.
INFO: HDCP enable
an adaptor is connected.
Transmitter Panel
The Control menu
Two channels are used for the USB communication, which can be set as described in the USB Modes
mode.
Parameter State and Description
Connected
USB Channel 1 mode Transparent (always)
USB Channel 1 state
Active
Not connected (it depends on the HID devices)
USB Channel 2 mode
Conguration
Transparent
USB Channel 2 status
Active
ATTENTION!
To Next Page
Loading...
