2. Product Overview DP-OPT-TX150, DP-OPT-RX150 – User's Manual 10
DP-OPT-RX150
Front View
1
POWER LED
▪ ON: the unit is powered on.
▪ BLINKING: an error has occurred and device is out of normal operation, or it is in bootload mode
2
FIBER LINK LED
▪ ON: the link is active between the extenders and ready to use.
▪ BLINKING: is no connection between the extenders.
3
SOURCE LED
▪ ON: powered DP source is connected to the transmitter.
▪ BLINKING: an HDMI adaptor cable is connected to the receiver to indicate HDMI mode operation.
4
▪ ON:
▪ OFF:
see the section.
5
USB LINK LED
▪ ON: HID extension is active.
▪ BLINKING: the USB channel is ready to use but HID extension is not active (e.g. there is no USB HID
device connected to the receiver or the computer is powered off).
▪ OFF: the USB channel between the extenders is not ready.
6
K+M EMULATE LED
▪ OFF: the transmitter is in transparent USB mode (default).
▪ BLINKING:
1 2 3 4 5 6
Rear View
1
DC connector
mountable power supply can also be used (PSU2x10-200 or PSU2x20-400).
2
USB mini-B connector USB mini-B type connector for control functions (with Lightware Device
3
USB-A ports Ports for USB HID (Human Interface Device, e.g. mouse, keyboard, or
presenter) and USB HUB devices (e.g. keyboard with built-in USB HUB).
Only HID devices are extended to the source computer. (The symbols are
just recommendations; mouse can be plugged into the port indicated with
keyboard-symbol and vice versa.)
4
DisplayPort output DisplayPort 1.1a output connector for display devices with DisplayPort
connector. The applied DP-DP cable shall not be more than 2 m. DP
adapters with DVI or HDMI connector are also supported. See the DP Input
and Output Ports section for more information about the connector.
5
SC Fiber connector
1 2 4 53
To Next Page
Loading...
