Page 20 / 60 Section 3. Controls and connections
3.11. HDMI-OPT-RX100 front view
Figure 3-9. Front view
Status LEDs The LEDs give feedback about the state of units and video
signal. For more information about names and meanings of the
Status LEDs see chapter 4.4.1.
3.12. HDMI-OPT-RX100 rear view
Figure 3-10. Rear view
HDMI OUT Connect one HDMI cable between the receiver unit and the
display device. For more information see chapter 3.13.1.
SC Fiber Input Connect a multimode single fiber optical cable between the
receiver unit and the transmitter unit (or a Lightware Hybrid
Modular Matrix equipped with optical output card)
DC +5V in Connect the output of the supplied +5V DC power adaptor.
CAUTION! Warranty void if damage occurs due to use of a
different power source. For more information see chapter 4.3.
To Next Page
Loading...
