Lightware HDMI-OPT-TX200R User Manual

HDMI-OPT-TX and RX family
User’s Manual
Section 4. Installation and operation Page 27 / 60
PRIMARY (SOLID) mode
 HDCP ENCRYPTED CONTENT or HDCP — Indicates if the source signal is HDCP
encrypted.
 HDMI SIGNAL or HDMI — Indicates the type of the video signal. In case of existing
HDMI signal the LED lights continuously. In case of existing DVI signal
the LED is off and the VIDEO CLOCK PRESENT LED is lights
continuously.
 VIDEO CLOCK PRESENT or VIDEO — Indicates if a valid HDMI clock signal is
present on the transmitters’ HDMI INPUT or the receivers’ SC
MULTIMODE IN connector.
 LINK – RECEIVER DETECTED — Indicates if a powered receiver (e.g.
HDMI-OPT-RX200R) is connected to the transmitter and they can
communicate over the fiber optical cable.
 LASER DETECTED or LASER — Indicates if a powered transmitter (e.g.
HDMI-OPT-TX200R) is connected to the receiver and they can
communicate over the fiber optical cable.
SECONDARY mode
 EMULATED EDID INVALID (TX200R/TX100R/TX100)
Function 1: The LED lights red if the selected EDID is invalid or empty
memory selected.
Function 2: After applying a Hot Plug signal(s) to the OUTPUT(s), this LED
indicates that the unit is trying to read the EDID from the
connected display device, but the EDID is invalid or missing.
Function 3: After pressing the LEARN button, this LED’s blinking indicates if
the learn process was unsuccessful.
 EMULATED EDID VALID (TX200R and RX200 and RX100RA)
Function 1: The LED lights green if the selected EDID is valid.
Function 2: After applying a Hot Plug signal(s) to the OUTPUT(s), this LED
indicates that the unit is reading the EDID from the connected
display device and the EDID is valid.
Function 3: After pressing the LEARN button, this LED’s blinking indicates if
the learn process was successful.
 MONITOR OUT HOTPLUG SENSE / OUT1 MONITOR HOTPLUG SENSE and
OUT2 MONITOR HOTPLUG SENSE
Function 1: Indicates if a powered display device (or matrix switcher,
repeater, etc.) is connected to the HDMI output connector and
sends a valid hotplug signal on pin 19 through the HDMI cable.
 SOURCE +5V SENSE
Function 1: Indicates if a powered source unit (computer, DVD or Blu-Ray
player, etc.) is connected to the HDMI INPUT connector and
sends a valid +5V signal on pin 18 through the HDMI cable.

Lightware HDMI-OPT-TX200R Specifications

General

Brand	Lightware
Model	HDMI-OPT-TX200R
Category	Receiver
Language	English