Lightware HDMI-TPS-TX226 - The Updating Steps

  

Device List


press the Add device button.
Legend of the Icons

IP address editor 

Identify me 
which helps to identify the device phisically.

Favorite device 


Further information
available
IP address
editor icon or use the front panel buttons (if available).

Cleartext login
enabled

       Parameters window or in the

Service mode The device is in bootload mode. Backup and restore cannot be
performed in this case.
The Updating Steps
ATTENTION!  

If any problem occurs, reboot the unit and restart the process.





1. Create a backup
   
computer.
2. Start the Update

3. Update

4. Factory reset



            

If the factory default option is selected in the Parameters window, the conversion / restore procedure will not
be performed!
6. Finish




