3. Product Overview HDMI20-OPTC series – User's Manual 18
Application Example with Break-out Connector
receiver pair with only one Neutrik opticalCON DUO cable. See the application example below.
The transmitter’s laser driver sends the signal through
Channel A. Channel B is directly connected to the
unit. Any optical signal can be transferred through this
channel in any direction.
The receiver’s laser sensor gets the signal through
Channel B. Channel A is directly connected to the break-
Any optical signal can be transferred through this
channel in any direction.
INFO: Break-out connector can be used in the same
way in all variants.
B
B A
B
B A
A
B A
A
B A
LC-LC fiber
optical cable
LC-LC fiber
optical cable
Neutrik opticalCON up to 700m
Source 1. Sink 1.
Sink 2.
Source 2.
A/V Video Signal 1.
A/V Video Signal 2.
HDMI
HDMI
HDMI
HDMI
Transmitter side
Receiver side
B
A
A
B
A
B
A
B A
A
B
B
LC-LC fiber
optical cable
LC-LC fiber
optical cable
Neutrik opticalCON up to 700m
Transmitter side Receiver side
Optical Interface
embedded audio, RS-232 and Ethernet signals. For more details about the supported cable extension
distances see Maximum Extension Distances section.
Port Diagram of Optical Interface
channel A and channel B. Since Lightware
INFO: Red line shows the main direction of the video signal. The blue line represents the optical signal via
B
A
HDMI
Out
B
A
A
B
Break-out
connector
Break-out
connector
Neutrik
connector
HDMI20-OPTC-RX220HDMI20-OPTC-TX220
Other ber device
Neutrik
connector
HDMI
splitter
HDMI
Input 1.
HDMI
Input 2.
HDMI
splitter
HDMI
Output
2.
Video
converer
HDMI
Output
1A.
HDMI
Output
1B.
Other ber device
To Next Page
Loading...
