HDMI20-OPTC series – User's Manual 50
Setting the Output Conversion Mode of the Remote Device
INFO: This command is available in transmitters.
Output conversion mode on the O1A and O1B ports of the receiver can
be also set by sending a command to the transmitter.
Command and Response
Ý
Ü
Parameters
See in the previous section.
Example
Ý
Ü
HDMI signal is split on the O1A (left) and O1B (right) ports of the
receiver. For more information see Output Conversion Modes section.
Querying the IP Address
Command and Response
Ý
Ü
Example
Ý
Ü
Command and Response
Ý
Ü
Example
Ý
Ü
Querying the Subnet Mask
Command and Response
Ý
Ü
Example
Ý
Ü
Command and Response
Ý
Ü
Example
Ý
Ü
Querying the Gateway Address
Command and Response
Ý
Ü
Example
Ý
Ü
Command and Response
Ý
Ü
Example
Ý
Ü
To Next Page
Loading...
