Lightware HDMI20-OPTC-TX220-Pro - 6.8. EDID Management Operations; 6.8.5. Copying EDID to User Memory; 6.8.6. Deleting EDID from User Memory; 6.8.7. Resetting Emulated EDIDs


 HDMI20-OPTC series – User's Manual 56
Copying an EDID to User Memory
Command and Response
ATTENTION!
Command and Response
Ý :)
Ü 
Parameters
 Parameter description Parameter values
 Source EDID memory place F#: Factory (F1-148)
U#: User (U1- U14)
D#: Dynamic (D1-D2)
 The desired User EDID memory slot U#: User (U1- U14)
Many copy operations can be performed at the same time by using semicolons (see Example2).
Example1:
Ý 
Ü 
Example2:
Ý 
Ü 
Deleting an EDID from User Memory
Command and Response
Ý )
Ü 
Parameters
 User EDID memory slot (U1-14)
Example
Ý 
Ü 
Resetting the Emulated EDIDs
Command and Response
Ý 
Ü 
Example
Ý 
Ü 
Calling this method switches all emulated EDIDs to factory default one. See the table in the Factory EDID
List section.



