Lightware HDMI20-OPTC-TX220-Pro - 7.5. Keeping the Configuration Settings


7. Firmware Upgrade HDMI20-OPTC series – User's Manual 61


been chosen in the parameters window, all device settings will be erased. LDC software contain the backup


1
Start of the Upgrade

2
Backup

Content of Backup File
section.
3
Upgrade

4
Factory reset

5
Conversion / Restore



When the factory default option is enabled in the Parameters window, the conversion / restore procedure
will not be performed!
6
End


                
          

Step 7. Select the desired devices and press the Start Update button. The upgrade takes about 5 minutes to

simultaneously.
Step 8.   
procedure. It is an automatic action and no any user interruption is needed during the operation.
Step 9. Finish. Clicking on the
 icon, a log information is displayed in the Device Log window.



