11. Appendix UMX-TPS-TX100 series – User's Manual 179
▪
▪
▪
▪
▪ Improved GPIO detection
▪
▪ Added 'User replaceable miniweb slot' to support built-in control webpage
▪ Added 'Forced button lock' function to lock buttons via protocol command
▪ Poe enable state is now reloaded after reboot.
▪ Input video parameter measurement speed improved.
▪
▪
▪ Event manager conditions did not work if DP input properties were selected.
▪ If the user switched to the currently selected port, the output was disconnected and connected again
unnecessarily, which resulted in a picture drop. Fixed.
▪
▪
▪ If the output was set to HDCP Always mode, the signal was sent out unencrypted, if the input port was
disconnected and connected again. This issue only happened, if the input signal was also unencrypted.
▪ If no sync screen is active, the output resolution is now reported correctly by the output port.
▪
▪ In case of sending 1920x1200 no sync screen, the device did not notice the connection state changes
on the inputs. Fixed.
v1.3.2b1
Release date: 2019-05-21
▪
v1.3.1b1
Release date: 2019-04-17
▪
v1.3.0b11
Release date: 2019-04-17
New feature:
▪
▪ Sending IR codes (SendProntoHex e.g. send max. 200 Byte IR code with Event Actions) for UMX-TPS-
TX140-Plus only!
▪
▪
▪ Fixed Event Manager condition linking
v1.2.1b8
Release date: 2019-01-29
New feature:
▪ Firmware platform library updated
▪
▪
▪
▪ Added 'Disable default button function' option to support button customization in Event Manager
▪ Added 'Forced button lock' function to lock buttons via protocol command
▪
▪
▪
▪ Improved GPIO detection speed (quick impulses can be detected, even low as 80ms)
v1.1.7b2
Release date: 2018-05-18
▪
v1.1.6b1
Release date: 2018-04-10
New feature:
▪ New control.html.
To Next Page
Loading...
Need help?
General
