11. Appendix UMX-TPS-TX100 series – User's Manual 180
v1.1.5b1
Release date: 2018-03-01
New feature:
▪ New miniweb.
v1.1.3b1
Release date: 2017-10-18
▪ Fixed GPIO PortUiCode.
v1.1.2b4
New feature:
▪ The text names of the ports are changed to be more precise, and less ambiguous.
▪
helps the user visually recognize the requested device.
▪
▪ Fixed a bug that made the 'continuously exists' timing mode unable to use.
▪ Fixed a bug that caused Event Manager's 47th event to be unlink-able.
v1.1.1b1
New feature:
▪
▪
▪ Event manager conditions did not work if DP input properties were selected.
▪ Input background measurement speed improved.
▪ If the user switched to the currently selected port, the output was disconnected and connected again
unnecessarily, which resulted in a picture drop. Fixed.
▪
v1.1.0b1
New feature:
▪ New EDID driver is used, the content of some factory EDID's are changed according to EDID 1.3 and
1.4 standard.
▪ EDID node properties changed: PreferredResolution, MonitorName and AudioInfo properties are added
▪ Audio and video port names are changed: 'I' is used for inputs and 'O' is used for outputs, instead of 'P'.
▪
▪ TCP and UDP messages can be sent by the device to control projectors and any other devices. This
feature can also be used with Event Manager.
▪
signal, and the received IR frames are also sent to this TCP connection.
▪ The device is able to identify IR commands on either the local or link IR input port. This feature can be
connected to Event Manager, which means, that the device can be programmed to do various actions,
▪ Factory default can be given in the board component.
▪ New bootloader is used, which allows the connected TPS-RX95's to be updated remotely.
▪
trigger multiple actions at the same time, inverse condition can be used.
▪ Dynamic edid can be deleted from code.
▪
▪
and the user interface shows if any of the conditions are met.
▪
▪ The method of storing device settings in EEPROM is updated, which may result in losing all the
▪ Default emulated edid for UmxAvFrontend handling changed.
▪
▪ If no sync screen is active, the output resolution is now reported correctly by the output port.
▪
▪
▪
To Next Page
Loading...
Need help?
General
