RF Meter Manual
Model 915
Series "B"
Form 403595 Section -
F60
Page -
5C
FEBRUARY 2006
(IOM-133-01 P/N 53400-133)
GENERAL
The RF meter is designed specifically to be used with the
LFC 2000 and LFC 2500 wireless Fluid Inventory Control and
Management Systems. The RF Meter will dispense bulk
fluids for servicing automobiles, trucks, buses, construction
equipment, and similar applications. The meter is lightweight,
rugged and has a comfortable grip. The meter is designed
specifically to dispense motor oils (S.A.E. 5-50), gear oils
(S.A.E. 80-240), automatic transmission fluid, and hydraulic
fluid.
A superior rugged, shock-resistant design for demanding
environments.
METER IS NOT FOR RESALE MEASUREMENT OF FLUID.
OPERATION
This unit can be programmed to dispense in quarts, liters,
pints, and gallons. A 5-digit liquid crystal display, accurate to
the second decimal point, shows the exact amount of fluid
dispensed.
The RF meter uses 4 replaceable AA batteries and is cali-
brated at the factory. The meter can also be recalibrated
easily in the field for a fluid of different viscosity.
LINCOLN’S FLUID INVENTORY CONTROL AND
MANAGEMENT SYSTEM OVERVIEW
Lincoln’s Fluid Inventory Control and Management Systems
have been designed to offer greater control over the dispens-
ing of fluids with significant reductions in installation costs
and the associated hardware common to most hard-wired
systems today. Dispensing information and authority is
communicated from the keypad to the meter with actual
dispensing information being communicated back to the
keypad utilizing 902-928 Mhz frequency hopping spread
spectrum radio communications.
Tracking of all dispenses, by PIN number, Work Order
number, fluid type, Meter/Hose number allows the software to
compute the remaining fluid balances.
TYPICAL APPLICATIONS
• Fleet Maintenance Shops
• Industrial Assembly
• Quick Lube Facilities
• Dealerships
• Construction and Mining Equipment
• General Automotive Service Centers
• Specialty Service and Repair Shops
IMPORTANT NOTE: The automatic nozzle requires 60 PSI to
open and function properly. A pump exceeding 60 PSI is
required for adequate flow and proper operation. A pump ratio
of at least 3:1 is recommended.
RF METER
FEATURES
• Oval Gear Driven Meter
• Durable, Rugged Design
• Rubber Boot
• Large, Easy-to-Read LCD Display
• RF Communication Indicator
• RF Controlled Meter
• Totalization in Liters and Gallons
• Delivery in Liters, quarts, Pints, Gallons
• Automatic Non-Drip Nozzle with manual shut-off feature
• Max. Totalizer Number: 99,999 Gallons or Liters
• Max. Dispense Volume: 99,999 Units
• Max. Preset Volume: 99.9 Units
• Calibration Factor for Different Fluids
• Changeable Units of Measure
• Total and Resettable Total
•Low Battery Indicator
• Low Battery Safety Lock Out Feature
• Uses Standard AA Batteries
• In-Line Swivel
• Automatic Shut-Off at Preset Amount
• Emergency Electrical Shut-Off
• Precision Control Valve Operation
FCC ID: GIF-RF KEYPAD
FCC CERTIFIED, PART 15, SUBPART C
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
To order call 1-800-548-1191 or visit www.partdeal.com - info@partdeal.com
To Next Page
Need help?
General
