___________________________________________________________________________________________________________________________________________________________________________________________
___________________________________________________________________________________________________________________
Form 403595 Page Number - 12
OPERATING MODE FUNCTIONS
These functions operate the same in RF Mode and EPM Mode.
Re-settable/Accumulated Totals
The meter has two flow totalizers. One is Re-settable Total the other is Accumulated Total.
1. To see the Accumulated Total and the Re-settable Total:
• Press and hold the
button to see the Accumulated Total.
• Continue holding the button.
• After three seconds the screen changes to the Re-settable Total.
2. Resettotal displays the total fluid dispensed since the Re-
settable Total was last set back to zero.
3. Press the button while viewing Resettotal to set it back
to zero.
4. Release the button to return to the operating display.
NOTE:
The Accumulated Total cannot be reset unless the user changes from English units to metric units
or from metric to English units. (See Change Factory Settings, Change Unit of Measure, on page 11).
Emergency Override
In case of an emergency or to interrupt a batch, the meter is equipped with an Emergency
Override.
1. Press the red button to activate the Emergency Override.
The override closes the valve, immediately stopping fluid flow.
2. Batching can continue after an Emergency Override by pulling up on the trigger.
Re-settable Total
To order call 1-800-548-1191 or visit www.partdeal.com - info@partdeal.com
To Next Page
Loading...
Need help?
General
