___________________________________________________________________________________________________________________________________________________________________________________________
___________________________________________________________________________________________________________________
Form 403595 Page Number - 9
Error Codes
The meter has several Error Codes that may display. These provide indication, at the meter, that
there is an error in communication between the meter and keypad.
F01 The meter has received an invalid response from the keypad.
• To clear the error, press the Reset button on the meter.
• Press the Reset button a second time to retry communications with the keypad.
F02 The meter has not received a response from the keypad during communications.
• To clear the error code, press the Reset button on the meter.
• To retry communications with the keypad, press the Reset button a second time.
• There may be an obstruction blocking the RF signal between the meter and keypad.
It may be necessary to change your physical location.
F04 There is a damaged cable assembly within the meter.
• This meter should be taken out of service.
• This meter may be used reliably in EPM Mode.
• RF Mode will exhibit erratic behavior.
SF0 (Scale Factor 0) The Scale Factor setting for the meter is set to 0.000.
• To input a valid Scale Factor for the meter follow the instructions in the “Change Factory
Settings” section of this manual, pages 11 and 12.
All other Error Codes are for factory purposes only.
• To clear the meter, press Reset.
To order call 1-800-548-1191 or visit www.partdeal.com - info@partdeal.com
To Next Page
Loading...
Need help?
General
