15
LT360 Precision Turntable
DLL Programming Manual
Error - 11: Display Controller Address Failure
This error indicates that the CPU in the LT360 cannot communicate with the
display controller. This error should never occur. If it does, a failure of a
component in the LT360 is indicated.
Error - 12: Switch Controller Address Failure
This error indicates that the CPU in the LT360 cannot communicate with the
switch controller. This error should never occur. If it does, a failure of a
component in the LT360 is indicated.
Error - 13: Torque Controller Address Failure
This error indicates that the CPU in the LT360 cannot communicate with the
stepper motor torque DAC controller. This error should never occur. If it
does, a failure of a component in the LT360 is indicated.
Error - 14: Output Controller Address Failure
This error indicates that the CPU in the LT360 cannot communicate with the
analog output DAC controller. This error should never occur. If it does, a
failure of a component in the LT360 is indicated.
To Next Page
Loading...
