LinearX LT360 - Get Step Size

53
LT360 Precision Turntable
DLL Programming Manual
■ Class Get (in)
■ Identifier lt_GetStepSize
■ Hex Value 0x9F
■ Call LT360LIB_CmdValue(Handle, lt_GetStepSize, RtnStr);
■ Returns 'nnn.n'
Description
This command returns the step size value. The value is returned as a
string with tenths of a degree precision, and is always positive. This
value sets the angular step size by which the platter will rotate to either
a step command or TTL pulse.
The minimum step size is 0.1 degrees. Step size is always positive.
Direction is controlled by the CCW/CW commands listed else where.
2.35 Get Step Size