LinearX LT360 - Set Display Polarity

34
LT360 Precision Turntable
DLL Programming Manual
■ Class Set (out)
■ Identifier lt_SetDisplayPolarity
■ Hex Value 0x34
■ Call LT360LIB_CmdValue(Handle, lt_SetDisplayPolarity, 'xxxxxxx');
■ Parameter 'UNIPOLAR' or 'BIPOLAR'
2.17 Set Display Polarity
Description
This command changes how the LT360 represents the degree position
on the front display of the chassis, and in the Win32 software. When
DisplayPolarity is set to UNIPOLAR, the LT360 will display the position
in the range of 0 to 360 degrees. All position values are positive. When
it is set to BIPOLAR, the range will be 0 to ±180 degrees. Both positive
and negative values will be shown.