LinearX LT360 - Step CW

20
LT360 Precision Turntable
DLL Programming Manual
■ Class Set (out)
■ Identifier lt_Step_CW
■ Hex Value 0x1F
■ Call LT360LIB_CmdValue(Handle, lt_Step_CW, null);
■ Parameter (none)
Description
This command causes the LT360 to move from its current position by
the current step size using clockwise rotation. No parameter is re-
quired.
The step command can also be issued from the front panel of the unit,
the LR360 remote, or by the TTL Pulse input on the front panel.
The parameter value should have tenths of a degree precision, and may
be either unipolar (0..360.0) or bipolar (0..±180.0).
2.4 Step CW