LinearX LT360 - Get Calibration Date

46
LT360 Precision Turntable
DLL Programming Manual
■ Class Get (in)
■ Identifier lt_GetCalDate
■ Hex Value 0x98
■ Call LT360LIB_CmdValue(Handle, lt_GetCalDate, RtnStr);
■ Returns 'mmm-dd-yyyy'
Description
This command returns the date when the LT360 was last calibrated. For
example: JAN-01-2006 The date value is returned as a string.
Calibration is performed using the Win32 application software. Calibration
is performed originally at the factory, and in most cases will be permanent
and not be required again. It is possible for a customer to performed the
calibration, but only if the proper equipment is available. The computer
must have a GPIB bus, and two 6-1/2 digit DMMs are required themselves
with accurate recent calibration. See the LT360 Manual for further details.
2.28 Get Calibration Date