D9U001PPB-0101 37/106
8 Setting the product
► Check all delivered items after unpacking
► Install the equipment and accessories
► Install front panel (in case of beds with dismountable front panels)
► Always install the bed on even floors
► When installing the bed, avoid collision with power supply cable or excessive tensioning of the
cable
► Check correct plugging in
► Avoid lose extension cables/ power socket bars lying on the floor
► Check all mechanical and electric protection elements are in place
► The bed has not any central switch. When disconnecting from power mains, plug off power
cable
► The power cable should always be accessible
► The power cable must not be connected through an extension cord and it must not be
connected to common multisocket inlets (trhree-way hub etc.)
► No input cable of other devices can lead over the surfaces of the bed or over the patient.
When moving the bed, avoid pinching/kinking of any objects
► Pay attention to proper fixing of the approved accessories listed in the manual
► The birthing bed is installed by trained person. It can be operated in ordinary way by trained
personnel only. Trained personnel must be also educated on appropriate height of infusion
stand setting
► The training is provided by L I N E T spol. s r.o. (manufacturer) representative or its authorized
dealership
We recomend to set up the bed into the Welcome position
► Straight "horizontal" position at the lowest possible height of the bed
► The foot section and legrests is extended and set in the highest position, where it serves as
a lying area
► The bed is covered with government-issue sheets / disposable drapes
► Side handles are in the active position; safety function
► The hand grips are hidden away so they do not get in the way when the mother enters the
bed
► When the room is made dim in order to create a more pleasing atmosphere, the backlight of
the bed is switched on
► The wheels are braked with a central brake
► The staff always briefly instruct the mother on how to use the bed (control the basic functions,
the bed's adjustment) and showing the warning labels
To Next Page
Loading...
Need help?
General
