EasyManuals Logo

Linksys LAPAC1750PRO User Manual

Linksys LAPAC1750PRO
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
86
Section 3: Configuring the Access Point
LAPAC1750PRO Access Point Software User Manual
Write Views Select the write access to management objects (MIBs) for
the group:
write-all The group can create, alter, and delete
MIBs.
write-none The group is not allowed to create, alter,
or delete MIBS.
Read Views Select the read access to management objects (MIBs) for
the group:
view-all The group is allowed to view and read all
MIBs.
view-none The group cannot view or read MIBs.
SNMP Groups This field shows the default groups and the groups that
have been defined on the AP.
Use the buttons on the page to perform the following tasks:
Add: Add the new group to the SNMP Groups table.
Remove: Remove the selected group from the SNMP Group table.
Save: Apply and save the changed SNMP group settings.
Targets
An SNMP target receives trap messages and forwards them to the SNMP
manager. Inform messages are not supported. Each target is associated with
target IP address, UDP port, and SNMP user name.
NOTE:
Required SNMP user configuration ”Users on page 87 should be
completed before configuring SNMP targets.
NOTE:
The access point supports a maximum of eight targets.
To display the SNMP Targets Configuration page, click the Configuration >
SNMP > Targets tab.
Figure 45: SNMP Targets

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys LAPAC1750PRO and is the answer not in the manual?

Linksys LAPAC1750PRO Specifications

General IconGeneral
Modulation-
VLAN supportYes
Frequency band2.4, 5 GHz
Number of users- user(s)
Channels quantity- channels
Networking standardsIEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3at, IEEE 802.3u
Ethernet LAN data rates10, 100, 1000 Mbit/s
Maximum data transfer rate1750 Mbit/s
InternalNo
CertificationFCC, CE, IC
Product colorWhite
Cable lock slot typeKensington
Ethernet LAN (RJ-45) ports2
Security algorithms802.1x RADIUS, WEP, WPA, WPA2
Antenna gain level (max)5.2 dBi
Input current2 A
AC input voltage12 V
Power consumption (typical)24 W
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 35 °C
Storage relative humidity (H-H)10 - 90 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth238 mm
Width247 mm
Height43.3 mm
Weight520 g

Related product manuals