Lippert SMART BED UNIVERSAL KIT - Page 17

Rev: 12.28.22 Page 17 CCD-0004051
7. If not already installed, install two 2.9 x 9.5 mm screws (Fig. 30N) one on each side of the ACS module
holder (Fig. 30A) holding the two half's of the ACS module holder together.
8. Slide the ACS module holder (Fig. 33B) underneath the angle support bracket (Fig. 33A). Align the angle
support bracket holes with the ACS Module holder. Attach with two screws 2.9 x 9.5mm (Fig. 33C) to
hold the ACS module holder to the angle bracket.
B
A
C
Fig. 33