Risk of burns due to hot components! Avoid any unnecessary touching!
•
Do not touch any hot parts (such as the heat sink) during operation. Only the DC
switch can safely be touched at any time.
Danger to life from electric shock due to live DC cables at the battery.
The DC cables connected to a battery may be live. Touching the DC conductors or the
live components leads to lethal electric shocks.
•
Do not touch non-insulated cable ends.
•
Do not touch any live components.
•
Observe all safety information of the battery manufacturer.
•
Prior to performing any work on the inverter or the battery, disconnect the inverter
from all voltage sources as described in this document.
•
If an error occurs, have it rectified by qualified persons only.
Risk of burns due to electric arcs.
•
Short-circuit currents in the battery can cause heat build-up and electric arcs.
•
Disconnect the battery from all voltages sources prior to performing any work on
the battery.
•
As soon as receiving the inverter please check if it is damaged during its
transportation. If yes, please contact your dealer immediately.
•
Adequate ventilation must be provided for inverter installation location.
•
Mount the inverter in vertical direction, and ensure that no objects block the heat
dissipation.
•
The safety instructions in this manual cannot cover all the precautions that
should be followed. Perform operations considering actual onsite conditions.
•
LIVOLTEK shall not be held liable for any damage caused by violation of the
safety instructions in this manual.
•
Before installing the inverter check all electrical ports to ensure no damage and no
short circuit, otherwise personal casualty and or fire will occur.
•
Input terminals of the PV inverter apply only to input terminals of PV String do not
connect any other DC source to the input terminals.
•
Before connecting PV Arrays ensure that is its voltage is within the safe range.
To Next Page
Loading...
