CHAPTER 8: OPERATION 8-14
ALPHA 538/552
SERVICE: Bar feeder setup
Automatic halt push forward at EOB
If this parameter is set to YES, the bar feeder don’t
push forward at end of bar (Only with Swiss type
lathe).
Hydraulic pump ON with front rest open
The hydraulic pump continues to supply oil to the
guiding channel.
Front rest closed on pusher
Only with fixed headstock lathe and only for Asian
market!
Close the front rest on the pusher during
machining.
Front rest opening is synchronized with lathe
clamping device opening.
This parameter reduces vibrations.
SERVICE: Bar feeder setup
Feed out safety tolerance
Tolerance added to the entered part length value to
avoid a groundless alarm. (default:10mm)
Position behind the clamping device
Position of the collet behind the clamping device
SERVICE: Torque & feed rate
Without bar stock
Pusher feed rate without bar stock
With clamping device closed
Pusher torque with clamping device closed
SERVICE: Torque & feed rate 2
Default values insertion/extraction: 100%
Default value Booster servo: 300%
To Next Page
Loading...
