Lockly SECURE User Manual

While in Programming Mode,
select “1AD” to add an Access
Code. If you are not in Pro-
gramming Mode, please see
Section 3.2 to enter Program-
ming Mode.
After pressing “1AD” press
“FP” to register a Fingerprint.
Upon pressing “FP”, you will enter Fingerprint Registration Mode and you will see a green
LED ring light up on the fingerprint panel on the exterior side of Lockly™ Secure Plus / Pro.
3.6 Adding a Fingerprint (Continued)
SECTION 3.6
Once you’re in Fingerprint Registration Mode you will see
two numbers displayed on keypad. The top number is your
Fingerprint Registration number, in this example to the left,
“1”. The bottom number will always start with a “6”.
You must successfully scan your fingerprint six (6) times for it
to properly register. Every time you scan your fingerprint, the
number on the bottom will change, starting from 6 - then 5, 4,
3, 2, 1, until the fingerprint is successfully registered.
Note: For reference, please keep a record of your fingerprint
registration number to distinguish whom it was registered to.
17

Lockly SECURE Specifications

General

Power Source	Battery
Compatibility	Standard doors
Operating Temperature	-4°F to 140°F (-20°C to 60°C)
Keyless Entry	Yes
Access Methods	Fingerprint, Keypad, Physical Key, Mobile App
Fingerprint Capacity	99 fingerprints
Connectivity	Bluetooth, Wi-Fi
Battery Life	Up to 1 year (depending on usage)
Keypad	Yes
Voice Control	Yes (Amazon Alexa, Google Assistant)
Door Thickness	1.375 to 2 inches
Battery Type	4 AA batteries
Mobile App	Lockly App
Auto-Lock	Yes
Weather Resistance	Yes
Installation	DIY
Lock Type	Smart Deadbolt
Material	Zinc Alloy