Loepfe YARNMASTER ZENIT+ - Managing Remaining Spindle Adjustments; Non-Pilot Spindle Adjustment with Fine Adjust; Troubleshooting Incomplete Pilot Adjustments; Condition for Starting Other Spindles

Quick Guide YM Zenit
+
20
5. Start remaining spindles
» If Reset Fine Adjust was selected in “Start Group”, an
adjustment will also be performed for each non-pilot
spindle.
If “Completed [x]” is displayed after adjustment, it was not possible to
complete adjustment with all pilot spindles (in this case it is recommend-
ed to repeat adjustment with other pilot spindles!)
The other spindles may be started only when adjustment status “Com-
pleted” is displayed!