Loepfe YARNMASTER ZENIT+ - Starting and Monitoring Production Groups; Selecting and Initiating a Group; Confirming Group Start Operation; Spindle Adjustment Status Monitoring

19
Quick Guide YM Zenit
+
17 Start Group
SETTINGS > Group (List)
1.
Select group.
2. Start group with .
» (Adjust) is displayed for all sensing heads.
3. Confirm pop-up “Start Group” with .
Spindle adjustment is started.
» “Production” is displayed in column “Status” and “Active” in column “Adjust”.
4. Start and monitor the respective number of pilot spindles individually.
» The “Ad” display goes out for each pilot spindle when adjustment is terminated.
After successful adjustment of all pilot spindles:
» “Completed” is displayed in column “Adjust”.
» The “Ad” display goes out for each non-pilot spindle when adjustment is terminated.