Lofa CANplus 1000 - Quick Access Menu

3. Display
The PIN being changed is the PIN for the current access level. Example: At User level, only the User
PIN can be changed. To change the Tech PIN, use the Elevate Access Level menu and enter the
correct Tech PIN. Then go to the PIN Change menu to change the Tech PIN.
Menu PIN Required OFF
• Accessing the menu is allowed with no PIN input required
• Only User access level items are displayed
• Use the Elevate Access Level menu to access Tech or Admin menu items
Menu PIN Required ON
• PIN is required to access the menu
• User, Tech, or Admin level access will be granted based on which PIN was entered. If PIN does
not match the User, Tech or Admin PIN, then the panel will display invalid PIN.
Once an access level is granted, that level is retained until the key is turned off. When the key is turn
back to the ON position, the access level reverts back to User and follows the Menu PIN Required
setting.
3.8.3 Quick Access Menu
The Quick Access Menu can accessed by pressing the menu control button . This menu has
commonly accessed menu items. All access levels open this menu and is not affected by the Menu
PIN Required setting. The following is the Quick Access Menu tree:
• Start-Stop with
• Operation
• Maintain Function
• Language
• Distance units
• Pressure units
• Volume units
• Temperature units
• High Set Point
• Low Set Point
• Target Point
• Autostart Dashboard
Page 18 LOFA document No. 463-3002-59 Page 18