LogTag Recorders UTRID-16 - Accessing Recorder Files

To Next Page

To Previous Page

If you have configured the UTRID-16 to generate files, these will be

created every time you plug the recorder into the USB port.

Once finished, USb will blink every second to indicate these files can

now be accessed.

a new drive or mounted device will appear. The device name will be

created from the serial number of the UTRID-16.

configuration.

While a UTRID-16 is plugged into USB, no temperature readings

are taken. The graph will display a gap and the data list will

show --- followed by the # symbol. This also applies when the

recorder is connected to a USB power supply.

Accessing the files

If the recorder was configured to generated files, a new drive or

mounted device will appear. The device name will be created from

the serial number of the UTRID-16. You can access the files by

browsing to the newly created drive and double-clicking the PDF,

CSV or LTD files. For PDF files you need Adobe Acrobat Reader or a

similar PDF viewer. To open the LTD file you need to install the free

LogTag

Analyzer software. CSV files can be opened with a text

editor, or imported into a spreadsheet program such as Microsoft

Excel

The file names contain information about the recorded data, which is

detailed in the section about Interpreting the Data on page1. If a

recorder has only taken pre-start readings, PDF and CSV files will not

be created.

You should copy the files generated by the recorder to a

permanent storage location on your computer, such as the

Documents folder, as they are not automatically copied.

The data on the unit is retained, and each time you plug the

UTRID-16 back into the computer the files are re-generated,

albeit with a new file name. Once the battery is exhausted,

however, the real time clock on the unit stops and dates and

times may no longer be accurate.

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com