LogTag Recorders UTRID-16 - UTRID-16 Start Options

To Next Page

To Previous Page

UTRID-16 Start Options

During configuration with LogTag

Analyzer you can decide when

the UTRID-16 starts taking temperature readings.

l ... via Push button start: The recorder will start taking

temperature readings after you have gone through a specific start

sequence of pressing and releasing the START/Mark button (see

Starting the Recorder on page1).

l ... via Date/Time start : The recorder will start taking

temperature readings at the date and time you specify (local

time).

When you choose the push button start option, you can select to

record pre-start readings or Begin recording after a delay.

l If you select pre-start readings, the UTRID-16 starts recording as

soon as it is unplugged from the USB port

and will continue to do

so until you start the unit. No alarms are processed while pre-

start readings are being taken, pre-start readings will not appear

in the PDF file, and no PDF file will be generated. Using pre-start

readings is a good way do avoid data loss if you forget to start the

unit, as you can stillaccess the data using LogTag

Analyzer.

l If you configure the UTRID-16 to start after a delay period, the

recorder will not immediately record temperature readings after

you have pressed START/Mark, but start a countdown timer

instead, and record readings only after the timer has ended. It

will, however, continue to take pre-start readings, if enabled.

You cannot combine a date/time start with pre-start readings or the

start delay function.

The first pre-start reading is taken one log interval after you unplug the unit from

the USB port.

www.GlobalTestSupply.com

Find Quality Products Online at: sales@GlobalTestSupply.com