20 Operating Your Appliance
© Travis Industries 100-01282_000 4111128
Catalytic Combustor – Use and Cleaning
This heater uses a catalytic combustor to improve efficiency and reduce emissions. To work at
its optimum, the combustor must be kept free of excessive ash. If the heater becomes sluggish
when the bypass is closed, flyash may be building up on the combustor. See the directions
below to inspect and clean the combustor with the included brush.
Inspecting & Cleaning the Combustor
The combustor becomes very hot during operation. Let the heater cool before cleaning the combustor.
The combustor is located directly above
the firebox opening. Make sure the
square openings are open for air to pass
through. If ash is accumulating, use the
brush to clear off visible flyash.
NOTE
: To thoroughly clean the
combustor, use an ash vacuum to pull
flyash from the combustor (see page 30).
Combustor
To Next Page
Loading...
