Declaration of conformity
- 25 -
11.18 909.1550.1-08
18 Maintenance and repair
Please heed the current safety and ac-
cident prevention regulations during all
maintenance and repair work.
The machine requires a minimum of care and mainte-
nance. Only a few items need to be checked to ensure
trouble-free long-term operation.
 Check the following points for damage before starting
up the welding machine,
– Mains plug and cable
– Welding torch and connections
– Ground cable and connection
– Keyboard membrane and control panel
 Check the dust lter every two months.
– Switch the machine off
– Disconnect the mains plug
– Unscrew the ventilation grid on the rear side
– Check the dust lter for pollution
– Replace the dust lter if it is polluted ( dust lter :
Order number 612.5193.0)
Use only original Lorch spare parts for
maintenance and repair.
If you experience problems or need re-
pairs, contact a dealer authorised by Lorch.
Never make repairs or technical changes
yourself. In this case the manufacturer's
warranty is no longer valid.
19 Disposal
Only for EU countries.
Do not dispose of electric tools together
with household waste material!
In observance of European Directive 2002/96/EC on
waste, electrical and electronic equipment and its imple-
mentation in accordance with national law, electric tools
that have reached the end of their service life must be
collected separately and returned to an environmentally
compatible recycling facility.
20 Service
Lorch Schweißtechnik GmbH
Im Anwänder 24 - 26
71549 Auenwald
Germany
Phone +49 (0) 7191 503-0
Fax +49 (0) 7191 503-199
21 Declaration of conformity
We herewith declare that this product was manufactured
in conformance with the following standards or ofcial
documents EN 60974-1:2012, EN 60974-3:2014, EN
60974-10:2007 CL.A in conformance with the guidelines
2014/35/EU, 2014/30/EU, 2011/65/EU.
2016
Wolfgang Grüb
Managing Director
Lorch Schweißtechnik GmbH
To Next Page
Loading...
Need help?
General
