150
The GPS Simulator menu.
Adjust the settings to your preferences, then turn on the simulator by
highlighting the
GPS SIMULATOR ON box and pressing ENT. Press EXIT re-
peatedly to close the menu. A message and tone appear periodically,
warning you the simulator is on. To turn off the simulator, repeat the
steps above or turn off the unit.
While in simulator mode, you can press
EXIT to clear the steering and
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor when running the simulator. To turn
on the steering and speed boxes again, return to the GPS Simulator
menu, select the
STEER WITH ARROWS command and press ENT. Press EXIT
repeatedly to get back to the main page display.
Simulating Trail or Route Navigation
To automatically follow a trail or route without manual steering:
1. From the Map Page, go to the simulator menu. Pick a
STARTING PO-
SITION
at or near the beginning of your trail/route. Enter an approximate
TRACK (shown in compass degrees) that will point you toward the start
of the trail/route.
2. Set
SPEED to zero. Select STEER WITH ARROWS command and press ENT,
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
EXIT to clear the alarm.) When navigation starts,
press ↑ to increase speed to the desired setting.
4. Press
EXIT to turn off the steering and speed boxes. The unit will now
automatically "steer" along the trail or route. When you arrive at your
"destination," cancel navigation as you normally do.
To Next Page
Loading...
Need help?
General