166
To change displayed data font size:
1. From the Map or Sonar page, press MENU|↓ to OVERLAY DATA|ENT.
2. Press ↓ ↑ to select the desired Data, then use ← → to change its size.
3. Press
EXIT to get back to the main page display, where the data will
be displayed in its new size.
NOTE:
Some data types can be displayed in only one font size. If that is the
case, the Data Size box will not be displayed for that data type.
Pop-up Help
Help is available for most all menu items in this unit. By highlighting a
menu item and leaving it highlighted for a few seconds, a pop-up mes-
sage appears that describes the function of the item. This feature is on
by default.
To activate Popup Help: Press
MENU|MENU|↓ to SYSTEM
SETUP|ENT|↓ to POPUP HELP. With the option highlighted, press ENT to
turn it on (check) or turn it off (uncheck). After the option is set, press
EXIT|EXIT to return to the page display.
The Pop-Up message that appears for Sounds.
Reset Options
To reset all features to factory defaults:
1. Press
MENU|MENU|↓ to SYSTEM SETUP|ENT|↓ to RESET OPTIONS|ENT|←
to
YES|ENT.
NOTE:
Reset Options does not erase any waypoints, routes, icons, plot trails or
sonar logs.
To Next Page
Loading...
Need help?
General