184
Waypoint Information screens with the Go To Waypoint command se-
lected (left) and the Find on Map command selected (right).
To return to the previous page, press EXIT repeatedly.
5. If you're looking by name, there are two options: A. You can spell out
the name in the top selection box. Press ↑ ↓ to change the first letter,
then press → to move the cursor to the next letter and repeat until the
name is correct, then press
ENT|ENT. B. Or you can jump down to the
lower selection list by pressing
ENT, then press ↓ ↑ to select a waypoint
from the list, then press
ENT. The waypoint information screen appears.
Find By Name menu (left). Waypoint Information screen (center). The
found waypoint is highlighted by the cursor on the Map Page (right).
A. To navigate to the waypoint, press ENT. The Go To Waypoint
command is already highlighted. The unit will show navigation in-
formation to the waypoint.
B. To find the waypoint, press ↓ to
FIND ON MAP|ENT. The Map Page
appears with the cursor highlighting the found waypoint.
To Next Page
Loading...
Need help?
General